act-dog

928 questions match

Science Evaluation of Models, Inferences & Experimental Results

A student claimed that heating tomatoes decreases the concentration of nutrients present. This claim is consistent with the results shown for which of vitamin C and lycopene, if either?

Open
Science Scientific Investigation

Assume that, in the experiments, the water bath contained pure water at standard atmospheric pressure (1 atmosphere; atm). While the bags containing the samples were being incubated, was the water in the water bath most likely boiling?

Open
Science Interpretation of Data

In Experiment 1, how many of the samples had a vitamin C concentration of less than 1.0 μmol/g tomato?

Open
Science Scientific Investigation

Consider the following procedures performed in Experiment 2 for Sample 2. 1. The sample was frozen. 2. The sample was incubated in the water bath. 3. The sample and solvent mixture was filtered. These procedures were performed in what order?

Open
Science Interpretation of Data

A linear region of a graph is a range of data that can be approximated with a straight line. Based on Figure 1, for Alloy Q initially at a temperature of 550°C, which of the following ranges of F best represents a linear region?

Open
Science Interpretation of Data

Consider the 2 trends shown for Alloy Q initially at the temperatures of 280°C and 550°C, from F = 40 × 10 through F = 48 × 10 . If these lines were to continue along the same trend, at which of the following values of F would the average crystal lengths most likely be the same?

Open
Science Interpretation of Data

Based on Figure 1, which of the following combinations of values for initial temperature and F would produce the shortest average crystal length in an ingot of Alloy Q? The smallest L would be produced with a temperature of:

Open
Science Interpretation of Data

The following table lists the mass of silicon in 50 g samples of 4 different alloys, one of which is Alloy Q. Mass of Si Sample (g) W 0.11 X 0.14 Y 2.7 Z 5.4 Given the composition of Alloy Q, which sample is most likely Alloy Q?

Open
Science Interpretation of Data

Based on Table 1, if an ingot of Alloy Q had a mass of 200 g, that ingot would contain what mass of Mg?

Open
Science field test

Based on the results of the studies, from which of the 5 leachates was the greatest percent of DOC adsorbed by CM1, CM2, and CM3, respectively?

Open
Science field test

Based on the results of Study 3, the percent of leachate DOC adsorbed by CM3, averaged across the 5 types of leaves, is closest to which of the following?

Open
Science field test

Is the statement “CM2 adsorbed a greater percent of the DOC in the maple leachate than did CM3” supported by the results of Studies 2 and 3?

Open
Science field test

Based on the results of the studies, which of the 3 clay minerals, if any, reduced the DOC in the oak leachate by more than 50%?

Open
Science field test

Is a mixture of any one of the leachates and any one of the clay minerals properly considered a solution?

Open
Science field test

In lake water, DOC is broken down into simpler compounds by electromagnetic energy in the visible wavelength range. What action was taken in the studies to prevent this process from occurring?

Open
Science Interpretation of Data

Consider the current shown on the ammeter in Figure 1. Based on the results of Experiment 2, when this current was measured, what was the relative intensity of the light?

Open
Science Scientific Investigation

What aspect of the experimental setup was held constant in Experiment 2 but not in Experiment 1?

Open
Science Interpretation of Data

Based on Figure 1, are the particles ejected from the metal plate moving toward the electrode or away from the electrode, and are those particles positively charged or negatively charged?

Open
Science Interpretation of Data

Based on the equation in the passage and the results of Experiment 1, what was the value of M for the metal plate used in the setup?

Open
Science Interpretation of Data

The cutoff frequency for a particular metal is the lowest frequency of light at which electrons are ejected from the metal. Based on the results of Experiment 1, the cutoff frequency for the metal plate was:

Open
Science Interpretation of Data figure

The relationship between E and the frequency of light is given by the equation: E = hf where h is Planck’s constant and f is the frequency of light. Based on the data for green light in Table 1, which of the following expressions could be used to determine the value of h? ____________ 5.6 × 10 Hz

Open
English Knowledge of Language

Which choice is least redundant in context?

Open
English Conventions of Standard English

Which choice makes the sentence most grammatically acceptable?

Open
English Conventions of Standard English

Which choice makes the sentence most grammatically acceptable?

Open
English Knowledge of Language

Which choice is least redundant in context?

Open